SOLD November 2002 - Another Rig like it in Process.  Estimated to be available in Mid 2003

CARRIER :   Custom T-18, 5 axle, fabricated steel chassis, one man cab with standard instruments, custom seat, hot water cab heater, defroster, windshield wiper, West Coast mirrors and air horn, rear mud flaps, Reyco front suspension 40,000 lbs. rating, Rockwell 44,000# rear tandem axles, Hendrickson rubber mounted rear suspension, Spicer 20,000 # rated tag axle, ten stud disc wheels front 22.5 x 13.0, rear 20.0 x 8.0, front tires - (4) 16.5 x 22.5  duplex, rear tires - (12) 10 x 20 extra grip, power steering, dual system air brakes on all wheels, BW Tu-Flo 1000 air compressor, GM 8V71N diesel engine, radiator, muffler, Allison 750  CLT DRD transmission with air shifting and dual shaft output, Spicer 1700 series drive lines, standard hiway 12 volt lighting and starting system, (2) 8 D 12 volt batteries with box and cover, (1) 125 gallon fuel tank, hydraulic tank, 40 GPM hydraulic pump, commercial shearing hydraulic control valve manifold, (4) hydraulic leveling jacks with locking screw rings, Braden 10,000 # hydraulic winch, full decking with folding wing and guard rails on operators side, (1) set of stairs with handrail, tool box, Mainland right angle gear box, hydramatic warer tank, air controls for transmission and drawworks, splash water system for drawworks, sand drum and main drum friction brakes, built in 3 step staircase on operators side, junk rack on operator side.
MAST: Pemco Model 96-180-C telescoping derrick, 96' clear working height, rectangular hollow section derrick frame with fabricated water table, 205,000 lbs. API rated static hook load on 6 lines, 6 sheave crown, 5 sheaves grooved for 1" main line, 1 sheave grooved for 9/16" sand line, block cradle, ladder, main guy lines, tubing and rod board with automatic raising, racking capacity 12,000' of 2 7/8" tubing, 12,000' of 7/8" rods, hydraulic raising and telescoping, air cylinder and controls for sucker rod transfer.
DRAWWORKS: Mainland M-40 double drum, rated main drum single line pull 37,500 lbs., fabricated plate frame with oil bath chain case for input and between drum chains, sandline controls at drawworks, main drum controls at driller's station, drums are fabricated steel, mounted on heat treated alloy shafts with spherical roller bearing, 15" double hydramatic brake with controls and water storage tank,  centralized lubrication system.
MAIN DRUM:   Barrel - 15" diameter x 39" long, grooved lagging - 1", drum flanges 42" diameter, brake drums - 40" diameter x 10 1/2" wide, brake blocks - 10" wide x 1 1/8" thick, clutch - twin disc PO-224, drum shaft - 5 1/2" diameter drum drive chain - 2" pitch single strand roller chain.
SAND DRUM:  Barrel - 13" x 39" line - smooth, drum flanges - 42" diamter, brake drums 40" diameter x 10 1/2" wide, brake  block - 10 1/2" wide x 1 1/8" thick, clutch - twin disc PO-224, drum drive -   1 " pitch, triple strand roller chain, Cathead - plain spool on operators side, maximum capacity - 9/16" line - 13,000'